LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> LS2 Standard >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System - Compressor Servicing >> NIPPONDENSO 10PA17/10PA17C 10-Cylinder >> Compressor Clutch Shaft Seal >> Removal

Compressor Clutch Shaft Seal: Removal

  1. Discharge A/C system, using approved refrigerant recovery/recycling equipment. Remove A/C compressor. Drain oil from compressor, and measure amount drained. Remove clutch hub, shims, rotor and pulley assembly, and clutch coil. See CLUTCH ASSEMBLY . See Figure.
  2. Remove front housing. Remove felt holder and felt washer from front housing. Remove shaft seal snap ring. Position front housing (nose up) on cardboard, placed on a flat surface. Using brass drift, press shaft seal from front housing.
scientia non olet · About LEMON Manuals