LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> LS2 Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System - Compressor Servicing >> SANDEN SD-7H15 7-Cylinder >> Clutch Assembly >> Removal (Ford Excursion, "F" Series Super Duty Pickup)

Removal (Ford Excursion, "F" Series Super Duty Pickup)

  1. Disconnect and isolate negative battery cable. Discharge A/C system, using approved refrigerant recovery/recycling equipment. Disconnect clutch coil harness connector and remove compressor. Drain oil from compressor, and measure amount drained.
  2. Using Spanner Wrench (T70P-4067-A), hold clutch plate and remove compressor shaft nut. See Figure. If necessary, use a steering wheel puller to remove clutch plate and shim(s).
  3. Using a flat-blade screwdriver, remove pulley assembly bearing dust cover. Remove compressor shaft key and internal bearing snap ring. Remove external front housing snap ring.
  4. Install jaws of rotor puller into pulley assembly internal bearing snap ring groove. Install shaft protector over compressor shaft. Install puller flange plate on jaws. Install 2 puller bolts through puller flange plate into jaws, and hand tighten. Tighten pulley center bolt clockwise and remove pulley assembly from compressor.
  5. Remove clutch coil wire harness retainer from compressor housing. Remove clutch coil snap ring and clutch coil.
scientia non olet · About LEMON Manuals