LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> LS1 Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transaxle Overhaul & Testing - 4T40-E & 4T45-E >> Component Disassembly, Reassembly & Transaxle Reassembly >> Forward Clutch Support & Low Roller Clutch Assembly >> Reassembly

Forward Clutch Support & Low Roller Clutch Assembly: Reassembly

  1. Install 2 NEW "O" rings on forward clutch support. See Figure . Install forward clutch support onto final drive sun gear shaft. Turn forward clutch support over. Install park lock gear thrust bearing. Install park lock gear onto final drive sun gear shaft with raised inner boss facing up so parking pawl properly engages teeth on park lock gear. Install snap ring to final drive sun gear shaft to retain park lock gear. Ensure clearance between park lock gear and snap ring is .120" (3.05 mm).
  2. Turn forward clutch support over. Install low roller clutch assembly onto forward clutch support. Larger tabs on cage must face down into forward clutch support. Rotate cage slightly counterclockwise to lock tabs into grooves in forward clutch support. Install forward clutch support thrust bearing (front).
  3. Install forward clutch support and low roller clutch assembly into transaxle case. Compress parking pawl return spring and align parking pawl with park lock gear. Install forward clutch support snap ring into transaxle case with chamfer side up. Snap ring opening must be toward bottom of transaxle case facing bottom pan. Use a screwdriver to set snap ring into place.
scientia non olet · About LEMON Manuals