LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> LS1 Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transaxle Overhaul & Testing - 4T40-E & 4T45-E >> Component Disassembly, Reassembly & Transaxle Reassembly >> Drive Sprocket Support Assembly >> Reassembly

Drive Sprocket Support Assembly: Reassembly

  1. Lubricate 2nd clutch piston seal with transaxle fluid. Install 2nd clutch piston assembly into driven sprocket support. See Figure . Install 2nd clutch spring assembly into driven sprocket support.
  2. Using Clutch Spring Compressor (J-23327) and Adapter (J-41232), compress 2nd clutch spring assembly and install spring retaining ring. Remove spring compressor and adapter. Install 2 NEW oil seal rings onto driven sprocket support. Air check 2nd clutch to ensure proper operation. Apply compressed air to 2nd clutch fluid circuit. See Figure . If clutch assembly does not operate properly, check component installation.
  3. Install driven sprocket support and 2nd clutch assembly into transaxle case. When installed properly, driven sprocket support will sit slightly below machined surface of transaxle case.
scientia non olet · About LEMON Manuals