LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> LS Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transaxle Overhaul & Testing - 4T40-E & 4T45-E >> Component Disassembly, Reassembly & Transaxle Reassembly >> Stub Shaft & Sleeve Assembly >> Reassembly

Stub Shaft & Sleeve Assembly: Reassembly

  1. Place output/stub shaft sleeve over end of output shaft. See Figure . Install collet into output shaft snap ring groove with collet attached to threaded collet shaft. Place sleeve installing tube over collet. Ensure small outside diameter of sleeve installing tube fits securely into output/stub shaft sleeve.
  2. Install bearing and nut onto threaded collet shaft. Hold end of threaded collet shaft while tightening nut to press sleeve onto output shaft. Remove sleeve installer. Install 2 NEW snap rings on stub shaft. Snap rings are not reusable once shaft is removed. Install stub shaft into transaxle. Use a mallet to install shaft through final drive differential gear.
scientia non olet · About LEMON Manuals