LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> LS Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transaxle Overhaul & Testing - 4T40-E & 4T45-E >> Component Disassembly, Reassembly & Transaxle Reassembly >> Stub Shaft & Sleeve Assembly >> Inspection

Stub Shaft & Sleeve Assembly: Inspection

NOTE: Sleeve Installer (J-41228) must be used to install sleeve onto stub shaft. Fluid leak may occur if sleeve installer is not used.

Check stub shaft for damage to splines, snap ring grooves and journals. Check sleeve for excessive wear, scratches or nicks which may cause a fluid leak or damage to seal. Replace stub shaft and sleeve as necessary. Clean and dry stub shaft and sleeve using compressed air.

scientia non olet · About LEMON Manuals