LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 2000 >> LS Automatic >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transaxle Overhaul & Testing - 4T40-E & 4T45-E >> Component Disassembly, Reassembly & Transaxle Reassembly >> Output Shaft Sleeve Assembly >> Reassembly

Output Shaft Sleeve Assembly: Reassembly

NOTE: Sleeve Installer (J-41228) must be used to install sleeve onto output shaft. Fluid leak may occur if sleeve installer is not used.

Place output/stub shaft sleeve over end of output shaft. See Fig 1 . Install collet into output shaft snap ring groove with collet attached to threaded collet shaft. Place sleeve installing tube over collet. Ensure small outside diameter of sleeve installing tube fits securely into output/stub shaft sleeve. Install bearing and nut onto threaded collet shaft. Hold end of threaded collet shaft while tightening nut to press sleeve onto output shaft. Remove sleeve installer. Install NEW snap ring into output shaft snap ring groove.

Fig 1: Installing Output Shaft Sleeve
G96E04284Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals