LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 1997 >> SW2 Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System - Compressor Servicing >> HARRISON Hd6/Ht6 & Hd6/Hr-6HE 6-Cylinder & V5 5-Cylinder >> Shaft Seal >> Removal

Shaft Seal: Removal

  1. Discharge A/C system, using approved refrigerant recovery/recycling equipment. Loosen and reposition compressor in mounting bracket. Remove clutch plate and hub assembly. See CLUTCH ASSEMBLY. See Figure or Figure .
  2. Remove shaft seal snap ring. Ensure all surfaces around seal are clean. Insert Shaft Seal Remover/Installer (J-23128-A) into shaft seal. Rotate handle clockwise to seat seal remover/installer in seal. Remove shaft seal. Using "O" Ring Remover (J-9553-01), remove "O" ring. Ensure shaft and inside of compressor neck are clean and free of foreign material. Thoroughly clean "O" ring groove in front head.
scientia non olet · About LEMON Manuals