LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 1997 >> SW2 Automatic >> Repair and Diagnosis (Single Page) >> Heating, Ventilation & A/C (HVAC) >> General Servicing >> HVAC System - Compressor Servicing >> HARRISON Hd6/Ht6 & Hd6/Hr-6HE 6-Cylinder & V5 5-Cylinder >> Shaft Seal >> Installation

Shaft Seal: Installation

  1. Install Shaft Seal Protector (J-34614) over compressor shaft. With shaft seal protector in place, lubricate new "O" ring with refrigerant oil and install it on "O" Ring Installer (J-33011).
  2. Insert "O" ring installer in compressor until it bottoms. Move slide on "O" ring installer downward until "O" ring is released into groove. Rotate installer to seat "O" ring. Remove "O" ring installer.
  3. Lubricate shaft seal with refrigerant oil. Install shaft seal onto Seal Installer (J-23128-A). Install shaft seal so flared side of lip seal is installed toward compressor. Expand seal using shaft seal remover/installer. Install shaft seal on Seal Protector (J-34614). Place seal protector over shaft.
  4. Push shaft seal into compressor using a rotary motion until seal bottoms. Install new snap ring with flat side against seal. Install clutch plate and hub assembly onto compressor shaft. See CLUTCH ASSEMBLY.
scientia non olet · About LEMON Manuals