Clutch Assembly: Removal
- Remove compressor from vehicle. Place compressor in Holding Fixture (J-33026 for HD6/HT6 and HD6/HR-6HE compressor or J-34992 for V5 compressor). On V5 compressor, use Clutch Plate Spanner (J-33027-A) to hold clutch plate. Remove compressor shaft nut using Shaft Nut Socket (J-33022). See Fig 1 .
- Use Clutch Plate Remover/Installer (J-33013-B) to remove compressor clutch plate and hub. See Fig 1 or Fig 2 . Hold remover body and turn center screw into remover body to remove clutch plate and hub. Ensure forcing tip on remover/installer center screw is flat or end of shaft/axial plate will be damaged. Remove key from shaft.
- Remove snap ring. Install Guide (J-33023-A) on front head. Position Pulley and Bearing Puller (J-41552 for HD6/HT6 and HD6/HR-6HE or J-33020 for V5 compressors) into inner circle of slots on pulley assembly. Turn puller clockwise in slots. Tighten puller and remove pulley assembly.
- If bearing is to be removed, remove forcing screw from puller. With puller still engaged in pulley slots, invert assembly onto a solid flat surface. Use a hammer and Bearing Remover (J-9398-A) to drive bearing from pulley. See Fig 1
or Fig 2
.NOTE: It is not necessary to remove staking in front of bearing before removing bearing.
- Disconnect clutch coil lead. Scribe marks on compressor and clutch coil for installation reference. Remove clutch coil using Puller Adapter (J-33023-A) and 2-jaw puller.