HARRISON Hd6/Ht6, Hd6/Hr-6HE 6-Cylinder & V5 5-Cylinder
- Operate system for several minutes to stabilize system, if possible. Turn engine off. Discharge A/C system, using approved refrigerant recovery/recycling equipment. Remove compressor. Drain refrigerant oil from compressor through suction and discharge ports, and drain plug. Measure amount of oil drained.
- If no oil leaks exist and more than one ounce is drained, add drained amount using new oil. If less than one ounce is drained from compressor, add 2 ounces of new oil.
- If replacing A/C components, add specified amount of refrigerant oil to system. See HD6/HT6, HD6/HR-6HE & V5 COMPONENT REFRIGERANT OIL CAPACITIES table. Install drain plug and compressor. Evacuate and charge system. Perform leak test.
NOTE:
Approximately 3 ounces of refrigerant oil, suspended in refrigerant, will be lost due to a large, abrupt leak. When replacing faulty component, add required amount of oil for component plus 3 ounces of oil to component. If oil cannot be easily added to component, add to accumulator/receiver-drier.
HD6/HT6, HD6/HR-6HE & V5 COMPONENT REFRIGERANT OIL CAPACITIES
| Component | Ounces | |||
|---|---|---|---|---|
| Accumulator/Receiver-Drier | ||||
| "G" & "N" Bodies | 3.5 | |||
| Except "G" & "N" Bodies | (1) | |||
| Condenser | 1.0 | |||
|
||||