LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 1997 >> SW2 Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 1.9L 4-CYL - VINS [7 & 8] >> Overhaul >> Cylinder Block Assembly >> Piston Rings

Piston Rings

If end gap and side clearance exceed specification, replace piston and/or rings. See PISTONS, PINS & RINGS  table under ENGINE SPECIFICATIONS. Ring No. 1 (top ring) is thinner than ring No. 2. Ring No. 1 can be installed either way. Ring No. 2 must be installed with mark on ring flat facing upward. Before installing piston, stagger ring end gaps 90-120 degrees apart.

scientia non olet · About LEMON Manuals