Vehicle Speed Sensor Replacement

REMOVAL
1. Position vehicle on lift and raise vehicle.
2. Disconnect electrical connector from Vehicle Speed Sensor (VSS) and remove.

INSTALLATION

IMPORTANT: Inspect O-ring for damage and replace if necessary.

1. Install VSS.
- Torque: 26N.m(19ft. lbs.).

IMPORTANT: Clean and lubricate fastener with Transaxle Fluid. Wipe off excess fluid and install.

2. Connect electrical connector to VSS. Push in until a click is heard and pull back to confirm positive engagement.
3. Lower vehicle.
4. Check transaxle fluid level.