Installation

1. Join hub, brake backing plate, and knuckle with four fasteners. Torque to specification.
- Torque: 85 Nm (63 lb ft)





2. Install brake rotor.
3. Install caliper onto knuckle and secure with two fasteners.
- Torque: 85 Nm (63 lb ft)
4. Connect electrical connector to ABS wheel speed sensor.

NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause wheel lug nuts to loosen in service.

5. Position wheel onto hub.
6. Install wheel nuts and tighten in a crisscross pattern. Repeat tightening pattern to make sure torque is correct.
- Torque: 140 Nm (103 lb ft)
7. Lower vehicle from hoist.