Installation

1. Join hub, brake backing plate, and knuckle with four fasteners and torque to specifications.
- Torque: 85 Nm (63 lb ft)
2. If vehicle is ABS equipped, plug ABS wheel speed sensor wiring harness into hub.
3. Install brake drum.

NOTICE: Before installing wheels, remove rust or corrosion from wheel mounting surfaces and brake rotors/drums. Failure to do so can cause wheel lug nuts to loosen in service.

4. Position wheel onto hub.
5. Install wheel nuts and tighten in a crisscross pattern. Repeat tightening pattern to make sure torque is correct.
- Torque: 140 Nm (103 lb ft)
6. Lower vehicle from hoist.