Removal

CAUTION: MAKE SURE VEHICLE IS PROPERLY SUPPORTED AND SQUARELY POSITIONED ON HOIST. TO HELP AVOID PERSONAL INJURY, PROVIDE ADDITIONAL SUPPORT TO THE OPPOSITE END OF THE VEHICLE THAT COMPONENTS WILL BE REMOVED FROM.

1. Raise vehicle on hoist.
2. Remove road wheel from the hub being replaced.
3. Disconnect electrical connector from ABS wheel speed sensor.





4. Remove two caliper-to-knuckle mounting bolts.
5. Suspend (using wire) the caliper assembly by the strut spring, clear of the knuckle.
6. Remove rotor from hub.
7. Remove four hub-to-knuckle bolts.
8. Remove hub.