LEMON Manuals: Even more car manuals for everyone
Home >> Saturn >> 1995 >> SW2 Automatic >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> 1.9L 4-CYL - VIN [7] (DOHC) >> Overhaul >> Cylinder Block Assembly >> Rod Bearings

Rod Bearings

  1. Mark cylinder number on bearing caps for reassembly reference. Rods and caps are match-marked with a color code at the factory. If connecting rod side clearance exceeds specification, replace connecting rod and/or crankshaft as necessary. Refer to the CONNECTING RODS  table under ENGINE SPECIFICATIONS.
  2. If the connecting rod bearing oil clearance exceeds maximum allowable specification, replace the bearings. Refer to the CRANKSHAFT, MAIN & CONNECTING ROD BEARINGS  table under ENGINE SPECIFICATIONS. If necessary, grind journals or replace crankshaft. DO NOT remove more than .010" (.25 mm) of metal from journals. Bearings are available in .010" (.25 mm) undersize.
scientia non olet · About LEMON Manuals