LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2011 >> 9-5 Turbo6 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting And Signaling Systems >> Fault diagnosis, symptoms >> Headlamps Malfunction >> Circuit/System Testing >> Low Beam Headlamp Malfunction - with HID Headlamps RPO TT2/TT6

Low Beam Headlamp Malfunction - with HID Headlamps RPO TT2/TT6

  1. Ignition OFF, disconnect the appropriate harness connector at the inoperative headlamps listed below:
    • E13L Headlamp Assembly - Left
    • E13R Headlamp Assembly - Right
  2. Test for less than 5 Ω between the appropriate headlamp ground circuit harness connector terminal 8 and ground.
  3. If greater than the specified range, test the ground circuit for an open/high resistance.
  4. Remove the appropriate fuse listed below:
    • F50 UA Left Low Beam
    • F49 UA Right Low Beam
  5. Ignition ON, verify that the appropriate headlamp does not illuminates.
  6. If the headlamp does illuminates, test the fuse output circuit for a short to voltage.
  7. Install a 10 A fused jumper wire between appropriate fuse output contact and B+. Verify that the appropriate low beam illuminates.
  8. If the headlamp does not illuminates, test the fuse output circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the appropriate bulb.
  9. Ignition OFF, disconnect the X5 harness connector at the K9 Body Control Module.
  10. Ignition ON, test for greater than 11 V between the control circuit terminal 13 X5 and ground.
  11. If less than the specified value, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the X50A Fuse Block - Underhood.
  12. If all circuit test normal, replace the K9 Body Control Module.
scientia non olet · About LEMON Manuals