With High Intensity Discharge (HID) Headlamps RPO TT6

The BCM controls the headlamps based on the inputs explained above. When a low beam request is received, the BCM grounds the headlamp low beam relay control circuit. This energizes the coil in the headlamp low beam relay, causing the relay switch to close. This then applies B+ to both low beam high intensity discharge (HID) headlamps through the left low beam and right low beam fuses, illuminating the low beam headlamps. When a high beam request is received, the BCM grounds the headlamp high beam relay control circuit. This energizes the coil in the high beam relay, causing the relay switch to close. This then applies B+ to both low beam HID headlamps through the left high beam and right high beam fuses, illuminating the high beam headlamps.