Instrument Panel Compartment Lamp Circuit Malfunction
- Ignition OFF, disconnect the harness connector at the E27 Instrument Panel Compartment Lamp.
- Test for less than 5 Ω between the ground circuit terminal 2 and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Ignition ON, test for greater than 11 V between the 12 V reference circuit terminal 1 and ground.
- If less than the specified value, test the circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.
- If all circuits test normal, test or replace the E27 Instrument Panel Compartment Lamp.