Courtesy Lamp Circuit Malfunction
- Ignition OFF, disconnect the harness connectors at the appropriate inoperative backlighting component.
- Test for less than 5 Ω between the black wire of the component and ground.
- If greater than the specified range, test the ground circuit for an open/high resistance.
- Connect a test lamp between the control circuit of the component grey wire and ground.
- Command the Courtesy Lamps Dimming ON and OFF with a scan tool.
- If the test lamp is always OFF, test the control circuit for a short to ground or open/high resistance. If the circuit tests normal, replace the K9 Body Control Module.
- If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the K9 Body Control Module.
- If all circuit test normal, test or replace the appropriate inoperative component.