LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2011 >> 9-5 Turbo6 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting And Signaling Systems >> Fault diagnosis, symptoms >> Adaptive Forward Lighting Malfunction >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the appropriate headlamp assembly.
  2. Test for less than 5 Ω between the E13L Headlamp Assembly - Left or E13R Headlamp Assembly - Right ground circuit terminal 8 and ground.
  3. If greater than the specified range, test the ground circuit for an open/high resistance.
  4. Test for less than 5 Ω between the K26 Headlamp Control Module ground circuit terminal 1 and ground.
  5. If greater than the specified range, test the ground circuit for an open/high resistance.
  6. Ignition ON, headlamps ON, connect a test lamp between the K26 Headlamp Control Module ignition circuit terminal 10 and ground. The test lamp should turn ON.
  7. If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
  8. Ignition OFF, disconnect the X2 harness connector at the K26 Headlamp Control Module
  9. Ignition ON, connect a test lamp between the ignition circuit terminal 9 X1 at the K26 Headlamp Control Module and ground. The test lamp should turn ON.
  10. If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
  11. If all circuits test normal, replace the appropriate headlamp assembly. Verify that the customer concern is not still present.
  12. If the customer concern is still present, replace the K26 Headlamp Control Module.
scientia non olet · About LEMON Manuals