LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2011 >> 9-5 Turbo6 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Headlights >> Lighting And Signaling Systems >> Fault diagnosis, fault codes >> DTC B3889: Trailer Brake Lamps Circuit >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, test for less than 5 Ω between the X88 Trailer Connector terminal 3, 11, 13 and ground.
  2. If greater than the specified value, test the appropriate ground circuit for an open circuit/high resistance.
  3. Connect a test lamp between the X88 Trailer Connector terminal 6 and ground.
  4. Command the Trailer Brake Lamps Active/Inactive test with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
  5. If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K68 Trailer Lighting Control Module.
  6. If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuits test normal, replace the K68 Trailer Lighting Control Module.
  7. If all the circuits test normal, test the brake lamp circuit at the trailer.
scientia non olet · About LEMON Manuals