Circuit/System Testing
- Ignition OFF, test for less than 5 Ω between the X88 Trailer Connector terminal 3, 11, 13 and ground.
- If greater than the specified value, test the appropriate ground circuit for an open circuit/high resistance.
- Connect a test lamp between the appropriate X88 Trailer Connector terminal listed below and ground.
- X88 Trailer Connector terminal 1
- X88 Trailer Connector terminal 4
- Command the appropriate Trailer Turn Signal Lamp Active/Inactive test with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
- If the test lamp is always ON, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K68 Trailer Lighting Control Module.
- If the test lamp is always OFF, test the signal circuit for a short to ground or an open/high resistance. If the circuits test normal, replace the K68 Trailer Lighting Control Module.
- If all the circuits test normal, test the appropriate turn signal lamp circuit at the trailer.