Relay Test
- Ignition OFF, disconnect the KR49 Headlamp Low Beam Relay.
- Test for 60-180 Ω between terminals 1 and 2.
- If the resistance is not within the specified range, replace the KR49 Headlamp Low Beam Relay.
- Test for infinite resistance between the following terminals:
- 1 and 3
- 3 and 5
- 2 and 5
- 1 and 3
- If not the specified value, replace the KR49 Headlamp Low Beam Relay.
- Install a 15 A fused jumper wire between relay terminal 1 and 12 V. Install a jumper wire between relay terminal 2 and ground. Test for less than 2 Ωbetween terminals 3 and 5.
- If greater than the specified range, replace the KR49 Headlamp Low Beam Relay.