Static Test
- Ignition OFF, disconnect the harness connector at the B37 Engine Oil Pressure Switch.
- Test for infinite resistance between the signal terminal listed below and ground with the switch in the open position.
- Terminal 1 except LDK
- Terminal A with LDK
- If not the specified value, replace the B37 Engine Oil Pressure Switch.
- Test for less than 5 Ω between the signal terminal listed below and ground with the switch in the closed position.
- Terminal 1 except LDK
- Terminal A with LDK
- If greater than the specified range, replace the B37 Engine Oil Pressure Switch.