"No Remote Detected" message - no start: Action

With this s/w update the scanning for the remote key has been changed from only searching with the antenna between the front seats twice to the following enhanced procedure:

MY 2010

Antenna between front seats search once
Antenna on dashboard search once
Antenna between front seats search once

MY 2011

Antenna between front seats search once
Antenna on dashboard search once
Antenna between front seats search once
Antenna on dashboard search once

This new scanning scheme will significantly improve the situation with a remote key that is not detected at start.

Since new BCM software is not available for MY10, the scan time will only give 3 searches.

MY 2010

Do not update BCM!

Update PEPS with software 13578648.

NOTE: Same part number as released previously but with new calibration file (12812278)

Do not update PEPS if software 13578648 with calibration file 12812278 already is downloaded.

MY 2011

Update PEPS with software 13578648

NOTE: Same part number as released previously but with new calibration file (12812278)

Do not update PEPS if software 13578648 with calibration file 12812278 already is downloaded.

Update BCM with software 13583452... (Will extend scan time to 4 searches)

Configure BCM

Do not update BCM if this software already is downloaded.

NOTE: In case there is a permanent failure and the remote key always must be located in the key pocket in the center console storage area when starting the engine.