LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2010 >> 9-3X Standard >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> Turbocharger System >> Repair Instructions >> Upper delivery pipe, charge air cooler >> To fit

To fit

IMPORTANT: To reduce the risk of hoses mounted on the delivery side of the turbocharger coming loose due to low friction at high air pressure, the hoses and connecting pieces must be cleaned thoroughly before fitting. Use a rag dampened with 93 160 907 Motip Dupli cleaning agent to wipe clean inside the ends of the hoses. Clean the connecting pieces as well. If hose clips are rusty or damaged, they must be replaced so the correct clamping force is maintained.
  1. Position the delivery pipe. Insert the bolts for the charge air pipe upper bracket.
    Fig 1: Identifying Delivery Pipe And Charge Air Pipe Upper Bracket Bolt
    G05053307Courtesy of SAAB-SCANIA OF AMERICA, INC.
  2. Raise the car.
  3. Fit the delivery pipe lower retaining bolt.
    Fig 2: Illustration For Step 3-4
    G05053308Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Fit the junction hose on the charge air pipe and tighten the hose clamp.
  5. Fit the Spoiler shield, front. See SPOILER SHIELD .
  6. Lower the car.
  7. Fit the charge air pipe upper bracket on the fan cowling.
    Fig 3: Illustration For Step 7-9
    G05053309Courtesy of SAAB-SCANIA OF AMERICA, INC.
  8. Fit the connector and the hose from the temperature/pressure sensor on the charge air pipe.
  9. Fit the hose clamps to the upper junction hose and tighten the hose clamps.
  10. Fit the engine cover.
scientia non olet · About LEMON Manuals