To fit

Fit the brake pads into the hydraulic body.

Fig 1: Fitting Brake Pads Into Hydraulic Body
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Put in place the hydraulic body and fit the guide pins and protective covers.
Tightening torque 28 Nm (21 lbf ft)
Fit the brake hose with new seals.
Tightening torque: 40 Nm (30 lbf ft)

Fig 2: Illustration For Steps 2-3
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fit the retaining spring to the brake caliper. Position the upper edge and center of the spring. Then press home the lower end of the spring. Make sure the lug engages.

Fig 3: Pressing Lower End Of Retaining Spring
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Remove the brake pedal clamp and refit FUSE 6, INSTRUMENT PANEL ELECTRICAL CENTRE 22 .
Bleed the brake system .
Fit the wheel.
Lower the car.
Depress the brake pedal repeatedly in order to press out the brake pistons.
Check the brake fluid level and top up as necessary.