LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2010 >> 9-3X Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System - FOOTBRAKE System >> Repair Instructions >> Brake fluid reservoir, LHD >> To fit

To fit

IMPORTANT: The EHPS system must not be run dry. Do not reuse drained fluid. Fill the hydraulic system with special fluid.
  1. Fit the level sensor to the brake fluid reservoir.
  2. Fit the brake fluid reservoir (B) onto the master cylinder and screw in the locking screw.
    Fig 1: Identifying Brake Fluid Reservoir And Connector
    G05061402Courtesy of SAAB-SCANIA OF AMERICA, INC.
  3. Plug in the connector (A) for the brake fluid reservoir's level sensor.
  4. Manual gearbox:  Connect the hose from the main clutch cylinder to the brake fluid reservoir.
  5. Fit the coolant reservoir.
  6. Bleed the brake system .
  7. Manual gearbox:  Bleed the clutch system.
  8. Remove the rag from under the brake fluid reservoir.
  9. Remove the wing cover from the left-hand front wing.
scientia non olet · About LEMON Manuals