LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2010 >> 9-3X Automatic >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System - FOOTBRAKE System >> Repair Instructions >> Brake disc, rear, 4WD >> To remove

To remove

  1. Raise the car.
  2. Remove the Wheel.
  3. Remove the retaining spring (A) from the brake caliper.
    Fig 1: Identifying Brake Caliper Retaining Spring
    G05564174Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Remove the bolts for the bushings (A), and fold down the anti-roll bar (B).
    Fig 2: Identifying Bushings Bolts And Anti-Roll Bar
    G05564134Courtesy of SAAB-SCANIA OF AMERICA, INC.
  5. Remove the hydraulic body and brake caliper holder as one unit (A) and hang it to one side using a cable tie.
    IMPORTANT: Be careful that the brake pipes do not get damaged.
    Fig 3: Identifying Brake Caliper Holder Unit
    G05564176Courtesy of SAAB-SCANIA OF AMERICA, INC.
  6. Remove the brake pads.
  7. Remove the brake disc locking bolt (A). Lift off the brake disc.
    Fig 4: Identifying Brake Disc Locking Bolt
    G05564177Courtesy of SAAB-SCANIA OF AMERICA, INC.
scientia non olet · About LEMON Manuals