To fit

Clean the contact surfaces between the steering swivel member and the brake caliper carrier.
Fit the brake caliper holder to the steering swivel member (A). Apply 74 96 268 Thread locking adhesive to the bolts.

Tightening torque 130 Nm +45° (96 lbf ft +45°)

Fig 1: Identifying Steering Swivel Member
Courtesy of SAAB-SCANIA OF AMERICA, INC.
As required: Tighten the joint for the upper suspension arm's bracket and the steering swivel member.
Tightening torque: 125 Nm +135° (92 lbf ft +135°)
Screw in the brake piston (A) if necessary with 89 96 969 RESETTING TOOL (B) and 89 96 977 ADAPTER (C).

Fig 2: Identifying Brake Piston, (89 96 969) Resetting Tool And (89 96 977) Adapter
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fit the brake pads to the holder and cut off the cable tie.
NOTE: Check that the inner pad locates in the piston's groove.
Fit the brake caliper with the guide pins (C) and the protective covers (B).
Tightening torque 28 Nm (21 lbf ft)

Fig 3: Identifying Retaining Spring, Protective Covers And Guide Pins
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Fit the retaining spring (A) to the brake caliper.
Fit the wheel.
Lower the car.
Depress the brake pedal repeatedly in order to press out the brake piston and the handbrake self adjustment.
Check the operation of the foot brake and handbrake.