Rear Suspension

Stabilizer Shaft Insulator Replacement

Removal Procedure

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




2. Remove the stabilizer shaft insulator clamp mounting nut.
3. Remove the stabilizer shaft insulator clamp.
4. Remove the stabilizer shaft insulator from the stabilizer shaft.

Installation Procedure




1. Install the stabilizer shaft insulator to the stabilizer shaft.
2. Install the stabilizer shaft insulator clamp.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the stabilizer shaft insulator clamp mounting nut and tighten to 75 Nm (55 ft. lbs.).
4. Lower the vehicle.