Low and Reverse Clutch Piston Removal

Low and Reverse Clutch Piston Removal

Tools Required
* J 23327-1 Forward Clutch Spring Compressor (Bridge)
* J 34627 Snap Ring Remover and Installer
* J-42628 Plate




1. Install the J 23327-1 and the J-42628.




2. Tighten the J 23327-1.
3. Remove the low and reverse clutch retainer ring (693) using the J 34627.
4. Remove the low and reverse clutch spring assembly (694).




5. Blow compressed air into the case passage to remove the low and reverse clutch piston (695).

* (1) LO Feed Passage
* (2) REV Feed Passage