Reverse Input Clutch Bushing Replacement

Reverse Input Clutch Bushing Replacement

Removal Procedure

Tools Required
* J 25019 Bushing Service Set
* J 34196-B Transmission Bushing Service Set
* J 7004-A Universal Remover
* J 8092 Driver Handle




1. Inspect the reverse input clutch housing and drum assembly for the following conditions:

* Damaged or worn bushings
* Surface finish on the hub and outer housing - check band surface for flatness
* Leak at the weld
* Heat distortion
* Rolled or distorted retaining ring groove




2. Using the J 25019-16 with the J 7004-A, remove the reverse input clutch front bushing (603).




3. Using the J 25019-4 with the J 8092, remove the reverse input clutch rear bushing (606).

Installation Procedure




1. Using the J 25019-9 with the J 8092, install a reverse input clutch front bushing (603).




2. Using the J 34196-3 which is part of kit J 34196-B with the J 8092, install a reverse input clutch rear bushing (606).