Canister Vent Valve: Service and Repair

Evaporative Emission Canister Vent Solenoid Valve Replacement

Removal Procedure

1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).




2. Disconnect the harness connector (2) from the evaporative emission (EVAP) canister vent valve.




3. Disconnect the EVAP vent pipe (3) from the EVAP canister vent valve (1).
4. Disengage the bracket retaining tab (2) and remove the EVAP canister vent valve.

Installation Procedure




1. Install the EVAP canister vent valve (1) on the bracket (2).
2. Inspect for proper retention of the EVAP vent valve (1) on the bracket (2).
3. Connect the EVAP vent pipe (3) to the EVAP canister vent valve (1).




4. Connect the harness connector (2) to the EVAP canister vent valve.
5. Lower the vehicle.