Rear Door Window Belt Outer Sealing Strip Replacement

Rear Door Window Belt Outer Sealing Strip Replacement

Removal Procedure




1. Remove the screw that retains the sealing strip to the door.
2. Lift upward on the forward edge of the sealing strip.
3. Remove the sealing strip from the pinch-weld flange.

Installation Procedure




1. Install the sealing strip to the pinch-weld flange, starting at the rear edge of the door.
2. Ensure that the sealing strip is fully seated to the pinch-weld flange.

Notice: Refer to Fastener Notice (Fastener Notice).

3. Install the screw that retains the sealing strip to the door.

Tighten the screw to 1.2 Nm (10 in. lbs.).