CHECK messages: General

SID can be used by all connected systems to show CHECK messages. When the ignition is turned ON, "CHECKING  " appears for approx. 4 seconds. Then a CHECK message is shown if active.

The following message is shown direct (without a 4 second delay):

• Key not accepted. Contact service.
• Tighten fuel filler cap.

The following message is displayed directly (without a 4 second delay) when the ignition key is turned from OFF to ON:

• Time for service. Contact service.
• Check engine oil level.

If a CHECK message is initiated, an acoustic signal is heard, the INFO DISPL lamp in the main instrument unit lights and a message is shown. If the message is preceded by a + sign, more than one message has been activated.

CHECK messages are shown in the following order of priority:

1. Key not accepted. Contact service.
2. Gearbox too hot. Make a safe stop.
3. Tighten fuel filler cap.
4. Stop for fuel.
5. Use your seatbelts.
6. Brake light failure.
7. Front light failure.
8. Fog light failure.
9. Rear light failure.
10. Washer fluid level low. Refill.
11. Coolant level low. Refill.
12. Theft protection failure. Contact service.
13. Remote control battery low. Replace battery.
14. Time for service. Contact service.
15. Check engine oil level.

"WASHER FLUID LEVEL LOW. REFILL.  " is shown after a 70 second delay and "COOLANT LEVEL LOW. REFILL  ." after a 30 second delay (N/A to ignition ON "CHECKING  ").

The driver can acknowledge a message by pressing the CLEAR button. If there is more than one message, the next message will appear. Acknowledged messages are not re-displayed. If the messages are not acknowledged, they will be deleted automatically from the display, one every minute.