LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2005 >> 9-5 Linear, Standard >> Repair and Diagnosis >> Accessories & Equipment >> Gauges & Instrument Panels >> ONSTAR - 9-5 >> Adjustment/Replacement >> Control module, VCIM, OnStar (5D) >> To fit

To fit

  1. When replacing a unit:  Make a note of the 10 digit station code (STID) and the 11 digit serial number (ESN) which are to be found on the new unit's label.
  2. Plug in the control module connector.
  3. Place the control module in the correct position. Make sure that the wiring harness is not pinched.
  4. Fit the control module, OIM, OnStar.
    NOTE: When replacing a VCIM, the OnStar system must be re-configured. If the re-configuration is neglected, or is not successful, the system will not function correctly.
    This system cannot be zeroed by depressing the "white dot" button as this will instead generate a fault code.
  5. Re-configure the OnStar system.
scientia non olet · About LEMON Manuals