LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2005 >> 9-5 Linear, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Body - 9-5 >> Adjustment-Replacement >> Rear outer wheel housing >> Removing

Rear outer wheel housing: Removing

Fig 1: Illustration For Step 3
G03865708Courtesy of SAAB-SCANIA OF AMERICA, INC.
  1. Position the car in an aligning bench.
  2. Remove the outer side panel.
  3. Drill out the spot-welds in the reinforcement by the sill.
  4. Knock away the reinforcement.
  5. Cut loose the wheel housing and remove it.
    Fig 2: Illustration For Step 5,7
    G03865709Courtesy of SAAB-SCANIA OF AMERICA, INC.
  6. Cut around the wheel housing as close to the edge as possible.
  7. Drill out the lower spot-welds on the reinforcement.
scientia non olet · About LEMON Manuals