To fit

Fig 1: Illustration For Step 1-2

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Fit the antenna amplifier and tighten the nuts.
Plug in all cables to the antenna amplifier.
Carefully lift up the headlining and fit the two clips in the roof.

Fig 2: Illustration For Step 3-6
Courtesy of SAAB-SCANIA OF AMERICA, INC.
Refit the C-pillar trims and fasteners over the rear side windows.
Fit the roof covers over the rear side windows and refit the D-pillar trim.
Plug in the lighting and fit the rear roof cover.
IMPORTANT: Handle the HF connector (2) with care. Exercise care when undoing the high frequency connector, Fuba GONOGO. Disconnection must be performed correctly so as not to damage the connector. See ANTENNA AMPLIFIER (4D)