LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2005 >> 9-5 Linear, Automatic >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Gauges & Instrument Panels >> ONSTAR - 9-5 >> Adjustment/Replacement >> Control module, VCIM, OnStar (4D) >> To fit

To fit

  1. When replacing a unit:  Make a note of the 10 digit station code (STID) and the 11 digit serial number (ESN) which are to be found on the new unit's label.
  2. Plug in the control module connector.
    Fig 1: Illustration For Step 2
    G03871504Courtesy of SAAB-SCANIA OF AMERICA, INC.
  3. Place the control module on the studs and fit the nuts.
    Fig 2: Illustration For Step 3
    G03871505Courtesy of SAAB-SCANIA OF AMERICA, INC.
  4. Fit the parcel shelf trim.
  5. Erase fault codes.
  6. Check that the system is functioning.
    NOTE: When replacing a VCIM, the OnStar system must be re-configured. If the re-configuration is neglected, or is not successful, the system will not function correctly.
    This system cannot be zeroed by depressing the "white dot" button as this will instead generate a fault code.
  7. Re-configure the OnStar system.
scientia non olet · About LEMON Manuals