TWICE uses the following information
INFORMATION USED BY TWICE
| Information | Value/Units | Off | The value is dependent on the following sensor input, signal or function |
|---|---|---|---|
| Identification number | MIU | The value is created in MIU when the immobilization code is programmed into TWICE. | |
| SID button | Night panel | SID | Button. TWICE uses the information for disconnecting the glass breakage sensor and tilt sensor. The Night Panel button is used for this purpose when the key has been removed from the ignition switch. |
| Ignition +B | ON/OFF | DICE | Ignition switch |
| Ignition +15 | ON/OFF | DICE | Ignition switch |
| Ignition +50 | ON/OFF | DICE | +15 present but not +54 |
| Ignition +54 | ON/OFF | DICE | Ignition switch. TWICE uses the information to inform the lamp check, seat belt warning, electrically heated rear seat and electrically adjustable front seat functions of the ignition switch status. |
| Ambient Temperature | °C | SID | Outdoor temperature, control module adjustment. TWICE uses the information to control the electric heating in the rear seat. |
| Seat-belt switch, driver | ON/OFF | SRS | Seat-belt buckle status, driver |
| Seat-belt switch, passenger | ON/OFF | SRS | Seat-belt buckle status, passenger |
| Wheel speed RL | 0-300 km/h | ESP | Speed sensor RL |
| Engine has started | ON/OFF | T7, diesel | When the engine has started, the engine control module sends the value ON. |
| Diagnostics communication | Tech 2 | See BUS AND DIAGNOSTICS COMMUNICATION . |