Customer settings

Fig 1: Identifying Customer Settings

Courtesy of SAAB-SCANIA OF AMERICA, INC.

Customer settings are carried out in three stages:

1. Press the CUSTOMIZE button.
2. Navigate to correct menu using the INFO button.
3. Press in the INFO knob to confirm a selection or press the CLEAR button to cancel a selection.

To exit from "CUSTOMER SETTINGS  ", navigate to Exit and press the INFO knob.

Further information on customer settings is available from the respective section in the Owner's manual.

The number of available selections in the menu depends on the car's equipment level. All the selections for the car are available when the ignition is on. To add or remove a function, e.g. if an accessory has been installed, the function will not be shown without first programming it with the diagnostic tool. Go to ADD/REMOVE  in the diagnostic tool menu and follow the instructions.

With the ignition key in LOCK position, there will be a limited choice of available selections, e.g. parking heater and alarm.

Setting a value: 

1. Select one of the functions with the INFO knob.
2. Keep the INFO knob pressed until an acknowledgment signal is heard.
3. Turn the INFO knob to change the value. The value can be deleted with the CLEAR button.
4. Complete the setting by pressing the INFO knob.