The OCP processor - Navigation and telephone software

The OCP processor (Open Computing Platform), which only exists in ICM 3, amongst other things handles the following:

• Colour screen and its menus
• Navigation (addresses, text and menus)
• Telephone (telephone book etc.)
• Advanced voice control.

The two separate software versions for VIP and OCP usually have internal dependence, which can make it necessary to update both software versions at the same time.

The OCP software can be updated in three different ways:

1. Complete update, UK English (retain personal data)
2. Complete update, UK English (clear personal data)
3. AVR Language (the spoken language for advanced voice control).

1. Complete update, UK English (retain personal data) 

   Updates all partitions except the boot partition, which also contains personal data with address books and voice stamps, etc. The AVR Language with this update will be UK English.

   If the customer uses any other language than UK English, the AVR language in the OCP processor must be changed. Change AVR language by selecting the "AVR language" option in TIS 2000.

2. Complete update, UK English (clear personal data) 

   Updates all partitions including the boot partition and consequently clears all personal data. The AVR language with this update will be UK English.

   If the customer uses any other language than UK English, the AVR language in the OCP processor must be changed. Change AVR language by selecting the "AVR language" option in TIS 2000.

3. AVR language 

   Changes the spoken language for AVR. Only the language partition will be updated. The following languages are available: French, German, UK English, Italian, Spanish, Swedish and US English.

   Fig 1: Identifying Flow Chart

   Courtesy of SAAB-SCANIA OF AMERICA, INC.
   NOTE: When updating ICM 3, it is recommended to update the VIP software before the OCP software. If necessary.