Tightening torques
TIGHTENING TORQUES
| Torque (Nm) | Torque (lbf ft) | |
|---|---|---|
| Brace, turbo/engine block | 24 | 17.7 |
| Bypass pipe, hose clip | 8 | 5.9 |
| Bypass pipe/intake manifold, banjo bolt | 8 | 5.9 |
| Clip, water return pipe, 4-cyl. | 9 | 6.6 |
| Crankcase breather pipe/intake manifold, banjo bolt | 24 | 17.7 |
| Exhaust manifold (rear and front)/cylinder head, V6 | 20 | 14.7 |
| Front/rear exhaust system | 22 | 16.2 |
| Heat shield, locknut, 4-cyl. | 20 | 14.7 |
| Heat shield, locknut, V6 | 24 | 17.7 |
| Heat shield, stud, V6 | 22 | 16.2 |
| Hose clip, inlet hose, charge air cooler | 8 | 5.9 |
| Intake manifold, screw, 4-cyl. | 24 | 17.7 |
| Intake manifold/U-clamp cylinder head, V6 | 14 | 10.3 |
| Oil pipe from turbo, M6 bolts (2), turbo | 14 | 10.3 |
| Oil pipe oil filter adapter, banjo bolt, 4-cyl. | 25 | 18.4 |
| Oil pipe to turbo, banjo bolt oil filter adapter, V6 | 20 | 14.7 |
| Oil pipe to turbo, banjo bolt, turbo | 20 | 14.7 |
| Radiator fan | 8 | 5.9 |
| Rear exhaust manifold/front exhaust manifold, V6 | 40 | 29.5 |
| Turbo/exhaust manifold, locknuts 4x, 4- cyl. | 24 | 17.7 |
| Turbo/exhaust manifold, studs 4x, 4-cyl. | 22 | 16.2 |
| Turbo/front exhaust system, locknuts (3) | 24 | 17.7 |
| Turbo/front exhaust system, studs (3) | 22 | 16.2 |
| V-clamp, turbo/intake manifold | 3 | 2.2 |
| Water pipe to turbo, banjo bolt, coolant pump, 4-cyl. | 20 | 14.7 |
| Water pipe to turbo, banjo bolt, turbo | 25 | 18.4 |
| Water pipe to turbo, retaining screw cylinder head, V6 | 14 | 10.3 |
| Water return pipe, cylinder head banjo bolt, 4-cyl. | 25 | 18.4 |
| Water return pipe, nipple on cylinder head, 4-cyl. | 35 | 25.8 |
| Water return pipe/turbo, banjo bolt | 25 | 18.4 |
NOTE:
In cases above where the engine type is not specified, the tightening torques apply for both the 4-cyl. and V6 engines.