LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2003 >> 9-3 Vector, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Hydraulic Brake System - FOOTBRAKE System (Late; 9440) >> Adjustment - Replacement >> Brake hose >> To fit

To fit

WARNING: When fitting new brake hoses it is very important that they are fitted in the correct position so that they do not come into contact with other parts of the car during suspension and steering movement.
The brake hoses must not be twisted. The front brake hoses should be fitted when the wheels are hanging freely and pointing straight ahead.
  1. Fit the new brake hose to the brake pipe.

    Tightening torque: 15 Nm (11 lbf ft) 

  2. Fit the hose and clip onto the bracket.
  3. Fit the hose to the brake caliper with new seals. Take care not to twist the hose.

    Tightening torque: 40 Nm (30 lbf ft) 

  4. Remove the brake pedal clamp.
  5. Refit fuse 6 into the instrument panel electrical center 22.
  6. Bleed the brake system.
  7. Fit the wheel.
  8. Check the brake hose connections for leakage.
  9. Lower the car.
scientia non olet · About LEMON Manuals