To Fit
WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Take care not to damage or loosen the energy absorbers. Damaged or loose energy absorbers must not be refitted. If the occasion should arise, the entire headlining must be changed. Damaged energy absorbers may impair head protection in case of a collision.
Fit in reverse order.
Tightening torque, seat-belt adjuster screws: 24 N.m (18 lbf ft) .
Fit the head guards where applicable. It is essential to keep to the dimensions shown in the illustration and that the rear guards are fitted parallel to the side of the roof.
In the event of fitting problems, the pads can be fastened to the roof as shown in the diagram and the headlining then fitted in the usual way.