LEMON Manuals: Even more car manuals for everyone
Home >> Saab >> 2003 >> 9-3 SE, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 35 (Interior Equipment) >> Adjustment - Replacement >> Luggage compartment trim, CV >> To Fit

To Fit

WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.

VIN 17000027-17000089, if new mat being fitted:  Remove the foam block on the right-hand side of the luggage compartment. Cut off the weld studs as close to the panel as possible.

  1. Fit the trim and fasten the clips at the front ends.
  2. Fit the load retention eye and tighten the bolt.
    Fig 1: Installing Clips & Retention Eye
    G03509932Courtesy of SAAB-SCANIA OF AMERICA, INC.

    Tightening torque: 25 N.m (18.5 lbf ft) 

  3. Fit the floor mat and fasten the clips.
  4. Plug in the connector for the luggage compartment lighting.
  5. Fasten the clips securing the trim at the sides.
  6. Fit the luggage compartment seal.
    Fig 2: Installing Luggage Compartment Seal
    G03509933Courtesy of SAAB-SCANIA OF AMERICA, INC.
  7. Refit the scuff plate.
scientia non olet · About LEMON Manuals