Noise from the upper part of the windscreen: Procedure
WARNING: This page is about a different car, the 2001 Saab 9-3. However, it is still accessible from the selected car via links, so may be relevant.
The noise can be eliminated after customer complaint by affixing double-sided adhesive tape between the top part of the windscreen trim and the metal roof.
If doing this when changing the windscreen, the tape should not be divided.
- Lift the trim from the upper part of the windscreen.
- Wash the edge of the metal roof and the contact surface where the trim meets the metal with Teroson cleaner FL or equivalent.
- Divide the tape while it is still on the card as illustrated.
- Centre the first piece of tape in the middle. Continue to apply two pieces of tape on each side and close to the middle one.
- Refit the trim.